Forum Home Forum Home > Moped2.org Forums > Moped
  New Posts New Posts RSS Feed - Bent crank
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Bent crank

 Post Reply Post Reply
Author
Message
Speedy View Drop Down
Newbie
Newbie


Joined: February/28/2010
Location: United States
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote Speedy Quote  Post ReplyReply Direct Link To This Post Topic: Bent crank
    Posted: March/01/2010 at 7:54am
I dug a puch maxi out of a pile.It was locked up.I got it unstuck.and found out why it had been discarded.On the mag side there is a small dent in the cover on the edge.The crank is bent,and I suspect the flywheel too.The flywheel has rubbed the stator and destroy that too.My question,Is there anybody out there that has the parts I need at a reasonable price.I think it is an 89 model.I really don't want to spend too much on it being it came out of a junk pile,but I would like to have it for a lake cruser.Thanks for any info you can give
Back to Top
Sponsored Links


Back to Top
donp View Drop Down
Admin Group
Admin Group
Avatar
Master Regional Rider

Joined: October/27/2003
Status: Offline
Points: 8560
Post Options Post Options   Thanks (0) Thanks(0)   Quote donp Quote  Post ReplyReply Direct Link To This Post Posted: March/02/2010 at 2:47am
is the crank shaft or crank arm bent? flywheels get bent easily when hit or pried on. but if the crankshaft is bent, then this bike might have been in a bad wreck or hit by a car and you should look every thing over very well before spending any money on it.
what engine is on it? the e-50 or za50? the za50 is a 2 speed. it's not a very desireable engine.
check out www.mopedjunkyard for parts breakdowns.
Back to Top
Speedy View Drop Down
Newbie
Newbie


Joined: February/28/2010
Location: United States
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote Speedy Quote  Post ReplyReply Direct Link To This Post Posted: March/02/2010 at 4:39am
It has hit something right on the mag cover there is a small dent right on the edge it,and the flywheel pushed it most of the way back out on the high side of the runout.The engine is single speed.
Back to Top
donp View Drop Down
Admin Group
Admin Group
Avatar
Master Regional Rider

Joined: October/27/2003
Status: Offline
Points: 8560
Post Options Post Options   Thanks (0) Thanks(0)   Quote donp Quote  Post ReplyReply Direct Link To This Post Posted: March/02/2010 at 2:41pm
thats the e50 which is a really good engine and a lot of parts are available for it.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

All my sites | Web Wiz Hosting Services | Privacy policy